Work Procedure

CHOOSE METHOD
1. There are three setting methods.
Which method do you choose?

With CONSULT >>

GO TO 2.

With set switch>>

GO TO 4.
WITH CONSULT - STEP 1
1. CONSULT Select "Work support" mode of "AUTO DRIVE POS.".
>>

GO TO 3.
WITH CONSULT - STEP 2
1. 1. Select the "EXIT SEAT SLIDE SETTING" or "EXIT TILT SETTING" in "Work support" mode of "AUTO DRIVE POS.", then touch display to change between ON and OFF.
    - EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
    - EXIT TILT SETTING: Entry/exit assist (steering column)
  2. Select the "SEAT SLIDE VOLUME SET" in "Work support" mode of "AUTO DRIVE POS.", and touch either of "40 mm", "80 mm", or "150 mm".
  3. Then touch "OK".
>>

Inspection End.
WITH SET SWITCH - STEP 1
1. Ignition switch OFF.
>>

GO TO 5.
WITH SET SWITCH - STEP 2
1. Push set switch and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
  - Entry/exit assist (seat/steering column) are ON: Memory switch indicator blink two times.
  - Entry/exit assist (seat/steering column) are OFF: Memory switch indicator blink once.
>>

Inspection End.