LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2022 >> QX60 Pure, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Exterior Lighting System >> Basic Inspection >> Sensor Initialize >> Work Procedure

Work Procedure

  1. VEHICLE CONDITION CHECK 
    1. Park the vehicle in the straight-forward position.
    2. Unload the vehicle (no passenger aboard).

    GO TO 2.

  2. SENSOR INITIALIZE 

    SYMBOL CONSULT

    1. Ignition switch ON.
    2. Select "SENSOR INITIALIZE" in "Work support" mode of "IPDM E/R".
    3. Touch "Start".
    4. When "INITIALISE COMPLETE", touch "End".
      NOTE: If "INITIALISE NOT DONE" is indicated, IPDM E/R detects that the front/rear height sensor signal changes and sensor initialize is cancelled. In this case, place the ignition switch to OFF to prevent the vehicle from height change and perform sensor initialize again.

    Is the sensor initialize completed?

    YES

    GO TO 3.

    NO

    Perform the sensor initialize again.

  3. SELF DIAGNOSTIC RESULT CHECK 

    SYMBOL CONSULT

    1. Select "Self Diagnostic Result" mode of "IPDM E/R".
    2. Check DTC.

    Is DTC detected?

    YES

    GO TO 2.

    NO

    Work End.