Removal and installation: Installation
WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Never spill or splash brake fluid on painted surfaces. Brake fluid may seriously damage paint. Wipe it off immediately and wash with water if it gets on a painted surface. For brake component parts, never wash them with water.
- Never depress brake pedal. while removing the brake tube. If this is not complied with, brake fluid may splash.
Note the following, and install in the reverse order of removal.
- Be careful not to damage electrically-driven intelligent brake unit stud bolt threads. If electrically-driven intelligent brake unit is tilted during installation, the dash panel may damage the threads.
- Never deform or bend the brake tubes when installing the electrically-driven intelligent brake unit.
- Temporarily tighten the brake tube flare nut to the electrically-driven intelligent brake unit by hand. Then tighten it to the specified torque with a crowfoot and torque wrench.
- Replace the clevis pin if it is damaged. Refer to "INSPECTION AND ADJUSTMENT ".
- Perform the air bleeding. Refer to "BLEEDING BRAKE SYSTEM ".
- Check each item of brake pedal. Adjust it if the measurement value is not the standard. Refer to "INSPECTION AND ADJUSTMENT ".
- Perform stroke sensor 0 point learning when electrically-driven intelligent brake unit is removed and installed, or replaced. Refer to "WORK PROCEDURE ".