LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2012 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Brake System) >> Ecu Diagnosis Information >> Electrically-Driven Intelligent Brake Unit >> Reference Value >> Consult Data Monitor Standard Value

Consult Data Monitor Standard Value

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
CONDITION REFERENCE

Monitor item Condition Reference values in normal operation
MASTER CYL PRESSURE Gradually depress the brake pedal Resistance value increases between 0.5 - 4.5 V according to the depth of brake depression.
MASTER CYL PRES (VDC) Gradually depress the brake pedal Resistance value increases between 0 - 25.6 MPa according to the depth of brake depression.
MOTOR TEMPERATURE Always 115 °C or less
CONTROL MODULE TEMP Always 150 °C or less
MST CYL PRES POWER VOLT Always 5.00 - 5.22 V
STROKE SEN 1 POWER VOLT Always 5.00 - 5.22 V
MOTOR POWER SUPPLY Always 4.28 - 28.0 V
CONTROL MODULE POWER Always 11.7 - 16.2 V
STROKE SEN 1 LEARN VALUE(1) Always -0.68 - 14.78 deg
STROKE SEN 2 LEARN VALUE(1) Always -0.68 - 14.78 deg
ALL SENSOR LEARNING(2) Learning not completed INCOMP
Learning completed COMP
STROKE SEN 1 OUTPUT VOLT(1) Gradually depress the brake pedal Resistance value increases between 0.51 - 4.59 V according to the depth of brake depression.
STEERING ANGLE SENSOR When driving straight 0±3.5°
When steering wheel is steered to RH by 90° Approx. -90°
When steering wheel is steered to LH by 90° Approx. +90°
DECEL G SENSOR Vehicle stopped Approx. 0 G
During acceleration Positive value
During deceleration Negative value
SIDE G SENSOR Vehicle stopped Approx. 0 m/s2
Right turn Negative value
Left turn Positive value
YAW RATE SENSOR SIGNAL Vehicle stopped Approx. 0 d/s
Right turn Negative value
Left turn Positive value
WHEEL SENSOR FRONT RH Vehicle stopped 0.00 km/h
Driving(3) Almost same reading as speedometer (within ±10%)
WHEEL SENSOR FRONT LH Vehicle stopped 0.00 km/h
Driving(3) Almost same reading as speedometer (within ±10%)
WHEEL SENSOR REAR RH Vehicle stopped 0.00 km/h
Driving(3) Almost same reading as speedometer (within ±10%)
WHEEL SENSOR REAR LH Vehicle stopped 0.00 km/h
Driving(3) Almost same reading as speedometer (within ±10%)
VEHICLE SPEED Vehicle stopped 0.00 km/h
Driving(3) Almost same reading as speedometer (within ±10%)
ACTUAL GEAR POSITION D position D
R position R
N or P position N/P
BRAKE SWITCH Brake pedal is depressed. On
Brake pedal is not depressed. OFF
COMMAND WAKE UP SLEEP When command is not input from BCM SLEEP
When command is input from BCM WAKEUP
DOOR SWITCH (BACK DOOR) Back door closed CLOSE
Back door open OPEN
DOOR SWITCH (REAR RH) Rear RH door closed CLOSE
Rear RH door open OPEN
DOOR SWITCH (REAR LH) Rear LH door closed CLOSE
Rear LH door open OPEN
DOOR SWITCH (FRONT RH) Front RH door closed CLOSE
Front RH door open OPEN
DOOR SWITCH (FRONT LH) Front LH door closed CLOSE
Front LH door open OPEN
IGNITION SIGNAL Power switch ON ON
Power switch other than ON OFF
READY STATUS READY status On
Other than READY status Off
BACKUP UNIT DIAG RESULT Normal NORMAL
Overvoltage ERR1
Communications malfunction ERR2
Charging circuit malfunction ERR3
Discharge circuit open ERR4
Discharge circuit shorted ERR5
Cell malfunction ERR6
Backup power circuit malfunction ERR7
Start signal malfunction ERR8
The control part is in abnormal condition ERR9
Monitor circuit malfunction ERR10
Insulation malfunction ERR11
Output circuit malfunction (other than discharge circuit) ERR12
Temperature detection circuit malfunction ERR13
Deteriorated ERR14
Outside the reference voltage ERR15
BACKUP UNIT MODE Backup power supply mode is active On
Backup power supply mode is not activated Off
BACKUP UNIT CHARGE STATUS 80% or less (backup power supply not possible) CHRG1
80 - 99%(backup power supply possible) CHRG2
100% (backup power supply possible) FULL
(1) The stroke sensor contains two circuits: stroke sensor 1 and stroke sensor 2.
(2) Learning for stroke sensor 1, stroke sensor 2, and master cylinder fluid pressure
(3) Check tire pressure under normal conditions.