LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> QX56 AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0327 To P0850 >> DTC P0448: EVAP Canister Vent Control Valve >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON and wait at least 5 seconds.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
  5. Start engine and let it idle for at least 1 minute.
  6. Repeat next procedures 3 times.
    1. Increase the engine speed up to 3, 000 to 3, 500 RPM and keep it for 2 minutes and 50 seconds to 3 minutes.

      Never exceed 3 minutes. 

    2. Fully released accelerator pedal and keep engine idle for about 5 seconds.
  7. Check 1st trip DTC.
  8. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

    If 1st trip DTC is not detected, go to the next step.

  9. Repeat next procedure 20 times.
    1. Quickly increase the engine speed up to 4, 000 to 4, 500 RPM or more and keep it for 25 to 30 seconds.
    2. Fully released accelerator pedal and keep engine idle for at least 35 seconds.
      Fig 1: Engine Speed Range
      G06315652Courtesy of NISSAN MOTOR CO., U.S.A.
  10. Check 1st trip DTC.
  11. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".