LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M45 Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System (SRS) >> Service Information >> Spiral Cable >> Removal and Installation >> Installation

Removal and Installation: Installation

Install in the reverse order of removal.

CAUTION:
  • The spiral cable may snap by steering operation if the cable is installed in an improper position.
  • The neutral position is set as follows.

    Turn quietly the spiral cable clockwise to the end position. Then turn it counterclockwise (about 2 and half turns) and stop turning at the point on which the stopper insertion holes are in the same position.

    The service part is installed in the neutral position by the stopper and can be set without adjusting after the stopper is removed.

  • Never turn the spiral cable rashly and also beyond the limit number of turns. (These will cause cable snap.)
  • Adjust the spiral cable locating pin (showed as A in the figure) to the steering wheel locating pin hole (showed as C in the figure).
  • Secure the air bag harness with the harness fixing hook.
    Fig 1: Adjusting Spiral Cable Locating Pin
    G04877012Courtesy of NISSAN MOTOR CO., U.S.A.
  • If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. Refer to "SRS OPERATION CHECK (USER MODE) ".
  • After the work is completed, check that no system malfunction is detected by air bag warning lamp.