LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M45 Base >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System (SRS) >> Service Information >> Side Curtain Air Bag Module >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the curtain air bag module.
    • Remove the headlining. Refer to "REMOVAL AND INSTALLATION ".
    • Remove the side curtain air bag module connector.
      NOTE:
      • For installing/removing side curtain air bag harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
      • Install connector with lock raised, and push lock into connector.
      • After installing the connector, make sure that the lock is pushed securely into it.
        Fig 1: Removing/Installing Harness Connectors
        G04887382Courtesy of NISSAN MOTOR CO., U.S.A.
    • Remove the curtain air bag module fixing bolts, and then remove the ground bolt.

      Fixing Bolt Torque Specifications : 10.8 N.m (1.1 kg-m, 8 ft-lb) 

      Ground bolt : 10.8 N.m (1.1 kg-m, 8 ft-lb) 

      CAUTION:
      • Leave the curtain air bag module with air bag deployment side facing upward.
      • Never impact the side curtain air bag module.
      • Replace the side curtain air bag module if it has been dropped or sustained an impact.
        Fig 2: Precaution For Air Bag Module
        G05224522Courtesy of NISSAN MOTOR CO., U.S.A.
      • Never insert any foreign objects (screwdriver, etc.) into side curtain air bag module.
      • Never disassemble side curtain air bag module.
      • Never expose the side curtain air bag module to temperatures exceeding 90 °C (194 °F).
      • Never allow oil, grease, detergent, or water to come in contact with the side curtain air bag module.