LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M45 Base >> Repair and Diagnosis >> Body & Frame >> Seats >> Service Information >> Automatic Drive Positioner >> Check Lifting Switch (Rear) Circuit

Check Lifting Switch (Rear) Circuit

  1. CHECK FUNCTION

    With CONSULT-III 

    With "LIFT RR SW-UP, LIFT RR SW-DN" on the DATA MONITOR, operate the lifting switch (rear) to check ON/OFF operation.

    MONITOR ITEM CHART

    Monitor item [OPERATION or UNIT] Contents
    LIFT RR SW-UP "ON/OFF" Operation (ON)/open (OFF) status judged from the RR lifter switch (UP) signal is displayed.
    LIFT RR SW-DN "ON/OFF" Operation (ON)/open (OFF) status judged from the RR lifter switch (DOWN) signal is displayed.

    Without CONSULT-III 

    1. Turn ignition switch OFF.
    2. Check voltage between driver seat control unit connector and ground.
      VOLTAGE SPECIFICATION

      Driver seat control unit connector Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      B204 14 Ground Lifting switch (rear) ON (DOWN operation) 0
      Other than above Battery voltage
      29 Lifting switch (rear) ON (UP operation) 0
      Other than above Battery voltage
      Fig 1: Checking Voltage Between Driver Seat Control Unit Connector And Ground
      G05212969Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: Lifting switch (rear) circuit is OK.

      NG: GO TO 2.

  2. CHECK LIFTING SWITCH (REAR) CIRCUIT HARNESS CONTINUITY
    1. Disconnect driver seat control unit and power seat switch connector.
    2. Check continuity between driver seat control unit connector and power seat switch connector.
      CONTINUITY CHART

      A B Continuity
      Driver seat control unit connector Terminal Power seat switch connector Terminal
      B204 14 B213 14 Yes
      29 29
    3. Check continuity between driver seat control unit connector and ground.
      CONTINUITY CHART

      A Ground Continuity
      Driver seat control unit connector Terminal
      B204 14 No
      29
      Fig 2: Checking Continuity Between Driver Seat Control Unit Connector And Ground
      G05212970Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: GO TO 3.

      NG: Repair or replace harness.

  3. CHECK LIFTING SWITCH (REAR)

    Check continuity between power seat switch as follows.

    CONTINUITY CHART

    Power seat switch Terminals Condition Continuity
    B213 14 32 Lifting switch (rear) ON (DOWN operation) Yes
    Other than above No
    29 Lifting switch (rear) ON (UP operation) Yes
    Other than above No
    Fig 3: Checking Continuity Between Power Seat Switch
    G05212971Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Replace driver seat control unit.

    NG: Replace power seat switch.