LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M45 Base >> Repair and Diagnosis >> Body & Frame >> Seats >> Service Information >> Automatic Drive Positioner >> Check Driver Seat Control Unit Power Supply and Ground Circuit

Check Driver Seat Control Unit Power Supply and Ground Circuit

  1. CHECK POWER SUPPLY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect driver seat control unit connector.
    3. Check voltage between driver seat control unit connector and ground.
      VOLTAGE SPECIFICATION

      Terminals Voltage (V) (Approx.)
      (+) (-)
      Driver seat control unit connector Terminal
      B205 33 Ground Battery voltage
      40
      Fig 1: Checking Voltage Between Driver Seat Control Unit Connector And Ground
      G05212898Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: GO TO 2.

      NG: Check the following.

      • Repair or replace harness between driver seat control unit and fuse block (J/B).
      • Circuit breaker.
  2. CHECK GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Check continuity between the driver seat control unit connector and ground.
      CONTINUITY CHART

      Driver seat control unit connector Terminal Ground Continuity
      B204 32 Yes
      B205 48
      Fig 2: Checking Continuity Between Driver Seat Control Unit Connector And Ground
      G05212899Courtesy of NISSAN MOTOR CO., U.S.A.

      OK or NG 

      OK: Driver seat control unit power supply and ground circuit are OK.

      NG: Repair or replace harness between driver seat control unit and ground.