LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2004 >> FX35 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Engine Control System) >> DTC P1065 ECM Power Supply >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check ECM Power Supply 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check voltage between ECM terminal 121 and ground with CONSULT-II or tester.
      1. Voltage: Battery voltage 

    OK or NG

    1. OK: go to  3 .
    2. NG: go to 2.
      Fig 1: Testing ECM Power Supply Circuit (W/DVOM)
      G00345098Courtesy of NISSAN MOTOR CO., U.S.A.

  2. Detect Malfunctioning Part 

    Check the following.

    • Harness connectors E211, M41
    • 20A fuse
    • IPDM E/R harness connector E8
    • Harness for open or short between ECM and battery
      1. Repair or replace harness or connectors.

  3. Check Intermittent Incident 

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT  .

    OK or NG

    1. OK: go to 4.
    2. NG: Repair or replace harness or connectors.

  4. Perform DTC Confirmation Procedure 

    With CONSULT-II 

    1. Turn ignition switch ON.
    2. Select SELF DIAG RESULTS mode with CONSULT-II.
    3. Touch ERASE.
    4. Perform DTC confirmation procedure  .

      See DTC CONFIRMATION PROCEDURE  .

    5. Is the 1st trip DTC P1065 displayed again?

    With GST 

    1. Turn ignition switch ON.
    2. Select MODE 4 with GST.
    3. Touch ERASE.
    4. Perform DTC confirmation procedure  .

      See DTC CONFIRMATION PROCEDURE  .

    5. Is the 1st trip DTC P1065 displayed again?

    Yes or No

    1. Yes: go to 5.
    2. No: Inspection end 

  5. Replace ECM 
    1. Replace ECM.
    2. Perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to ECM RE-COMMUNICATING FUNCTION .
    3. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING  .
    4. Perform THROTTLE VALVE CLOSED POSITION LEARNING  .
    5. Perform IDLE AIR VOLUME LEARNING  .
      1. Inspection end