LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2003 >> I35 >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System >> Power Steering Gear And Linkage >> Removal And Installation

Removal And Installation

Fig 1: Identifying Power Steering Gear Linkage System Components
G02091717Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
  • The rotation of the spiral cable (SRS "Air bag" component part) is limited. If the steering gear must be removed, set the front wheels in the straight-ahead direction. Do not rotate the steering column while the steering gear is removed.
  • Remove the steering wheel before removing the steering lower joint to avoid damaging the SRS spiral cable.
  • Detach tie-rod outer sockets from knuckle arms with Tool.
    Fig 2: Removing Tie-Rod Outer Sockets From Knuckle Arms
    G02091718Courtesy of NISSAN MOTOR CO., U.S.A.
  1. Remove front exhaust tube. Refer to REMOVAL AND INSTALLATION .
  2. Set a suitable transmission jack under transaxle.
    Fig 3: Locating Transmission Jack Under Transaxle
    G02091719Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove center member and rear engine mounting. Refer to REMOVAL .
  4. Remove front stabilizer bar. Refer to REMOVAL .
  5. Remove steering gear assembly.
    • Install pipe connector.
    • Observe specified tightening torque when tightening high-pressure and low- pressure pipe connectors. Excessive tightening will damage threads of connector or O-ring.
      1. Connector tightening torque: 
        1. Low-pressure side 

          27 - 39 N.m (2.8 - 4.0 kg-m, 20 - 29 ft-lb) 

        2. High-pressure side 

          15-25 N.m (1.5 - 2.5 kg-m, 11-18 ft-lb) 

          Fig 4: Identifying High-Pressure & Low-Pressure Pipe Connector
          G02091720Courtesy of NISSAN MOTOR CO., U.S.A.
    • The O-ring in low-pressure pipe connector is larger than that in high-pressure connector. Take care to install the proper O-ring.
    • Initially, tighten nut on tie-rod outer socket and knuckle arm to 29 to 39 N.m (3 to 4 kg-m, 22 to 29 ft-lb). Then tighten further to align nut groove with first pin hole so that cotter pin can be installed.
      CAUTION: Tightening torque must not exceed 49 N.m (5 kg-m, 36 ft-lb).
      Fig 5: Aligning Nut Groove With First Pin Hole
      G02091721Courtesy of NISSAN MOTOR CO., U.S.A.
    • Before removing lower joint from gear, set gear in neutral (wheels in straight-ahead position). After removing lower joint, put matching mark on pinion shaft and pinion housing to record neutral position.
      Fig 6: Putting Matching Mark Pinion Shaft & Pinion Housing
      G02091722Courtesy of NISSAN MOTOR CO., U.S.A.
    • To install, set left and right dust boots to equal deflection. Attach lower joint by aligning matching marks of pinion shaft and pinion housing.
    • Tighten gear housing mounting bracket bolts in the order shown in Fig 7.
      Fig 7: Tightening Order Of Gear Housing Mounting Bracket Bolts
      G02091723Courtesy of NISSAN MOTOR CO., U.S.A.