LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2003 >> I35 >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System >> Power Steering Gear And Linkage >> Adjustment

Power Steering Gear And Linkage: Adjustment

Adjust pinion rotating torque as follows:

  1. Set rack to the neutral position without fluid in the gear.
  2. Coat the adjusting screw with locking sealant and screw it in.
    Fig 1: Applying Sealant For Adjusting Screw
    G02091745Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Lightly tighten lock nut.
  4. Tighten adjusting screw to a torque of 4.9 to 5.9 N.m (50 to 60 kg-cm, 43 to 52 in-lb).
  5. Loosen adjusting screw, then retighten it to 0.2 N.m (2 kg-cm, 1.7 in-lb).
  6. Move rack over its entire stroke several times.
  7. Measure pinion rotating torque within the range of 180 degrees from neutral position. Stop the gear at the point of maximum torque.
    Fig 2: Measuring Pinion Rotating Torque
    G02091746Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Loosen adjusting screw, then retighten it to 4.9 N.m (50 kg-cm, 43 in-lb).
  9. Loosen adjusting screw by 60 to 80 degrees.
  10. Prevent adjusting screw from turning, and tighten lock nut to specified torque.
    Fig 3: Tightening Lock Nut
    G02091747Courtesy of NISSAN MOTOR CO., U.S.A.
  11. Check rack sliding force on vehicle as follows:
      Fig 4: Checking Rack Sliding Force
      G02091748Courtesy of NISSAN MOTOR CO., U.S.A.
    1. Install steering gear onto vehicle, but do not connect tie-rod to knuckle arm.
    2. Connect all piping and fill with steering fluid.
    3. Start engine and bleed air completely.
    4. Disconnect steering column lower joint from the gear.
    5. Keep engine at idle and make sure steering fluid has reached normal operating temperature.
    6. Pull tie-rod slowly to move it from neutral position to +/-1.5 mm (+/-0.453 in) at speed of 3.5 mm (0.138 in)/s. Check that rack sliding force is within specification.
      1. Average rack sliding force: 

        216 - 284 N (22 - 29 kg, 49 - 64 lb) 

      2. Maximum force deviation: 

        98 N (10 kg, 22 lb) 

    7. Check sliding force outside above range at rack speed of 40 mm (1.57 in)/s.
      1. Maximum rack sliding force: 

        294 N (30 kg, 66 lb) 

      2. Maximum force deviation: 

        147 N (15 kg, 33 lb) 

    • If rack sliding force is not within specification, readjust by repeating adjustment procedure from the beginning.
    • If rack sliding force is still out of specification after readjustment, gear assembly needs to be replaced.