DTC P1401 - EGR Temperature Sensor
- Check Power Supply Turn ignition off. Disconnect EGR temperature sensor harness connector. See Fig 1. Turn ignition on. Measure voltage between EGR temperature sensor connector terminal "1" (Blue/Orange wire) and ground. See Fig 2. If voltage is approximately 5 volts, go to next step. If voltage is not as specified, repair harness or connectors as necessary.
- Check Ground Circuit Turn ignition off. Verify harness continuity between EGR temperature sensor connector terminal "2" (Black wire) and engine ground. See Fig 3. If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
- Check Component Remove EGR temperature sensor. Immerse sensor in fluid. Measure resistance of EGR temperature sensor at about 212F 100C degrees. If resistance is 76,800-93,800 ohms, replace EGR temperature sensor and perform FINAL CHECK .
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.