DTC P1320 - Ignition Signal
- Check Power Supply Turn ignition off. Disconnect condenser and ignition coil harness connector. See Fig 1. Turn ignition on. Measure voltage between condenser connector terminal No. 1 and ground. See Fig 2. Measure voltage between ignition coil connector terminal No. 1 and ground. If battery voltage is present, go to next step. If battery voltage is not present, repair harness or connectors as necessary.
- Check Output Signal Circuit Turn ignition off. Disconnect ECM harness connector. Verify harness continuity between ignition coil connector terminal No. 3 and ECM terminals No. 1 ,2, 3, 7, 8 and 9. See Fig 3. If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
- Check Component With ignition coil disconnected, check for continuity between terminals. If no continuity is present, replace ignition coil. If continuity is present, check ECM connector terminals for corrosion or damage. Repair if necessary and perform FINAL CHECK .
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.