LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1996 >> I30 Base, Automatic, RE4F04A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes 3.0L >> Circuit Tests >> DTC P0705 - Inhibitor/Neutral Position Switch

DTC P0705 - Inhibitor/Neutral Position Switch

NOTE: Steps 1-3 are for A/T models. For M/T models, go to step 4.
  1. Check Power Circuit Turn ignition off. Disconnect inhibitor position switch wiring harness connector. See Fig 1. Turn ignition on. Measure voltage between inhibitor position switch connector terminal "3" (Green wire) and body ground. See Fig 2. If battery voltage is present, go to next step. If battery voltage is not present, repair harness or connectors as necessary.
  2. Check Output Signal Circuit Turn ignition off. Disconnect A/T control unit wiring harness connector. Check continuity between inhibitor position switch connector terminals No. "4" (Red/Green wire) and No. "6" (Red/Green wire) and A/T control unit terminal No. 19 (Red/Green wire). See Fig 3. If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
  3. Check Component Ensure inhibitor position switch is not damaged or contaminated. Check inhibitor position switch and ECM harness connectors for damage, corrosion or pushed-out pins. Repair if necessary. If no problems are found, replace inhibitor position switch.
    Fig 1: Locating Inhibitor Switch Harness Connector (I30)
    G96B10612Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: DTC 705, Checking Power Circuit (I30)
    G96C10613Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 3: DTC 705, Checking Output Signal Circuit (I30)
    G96D10614Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 4: DTC 705, Checking Output Signal Circuit (I30)
    G96E10615Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE: Steps 4-6 are for A/T models. For M/T models, go to step 1.
  4. Check Ground Circuit Turn ignition off. Disconnect neutral position switch wiring harness connector. See Fig 5. Check continuity between connector terminal "4" (Black wire) and body ground. See Fig 6. If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
  5. Check Input Signal Circuit Leave ignition off. Disconnect ECM harness connector. Check continuity between switch connector terminal "2" (Green/White wire) and ECM harness connector terminal No. 22. See Fig 7. If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
  6. Check Component Ensure neutral position switch is not damaged or contaminated. Check neutral position switch and ECM harness connectors for damage, corrosion or pushed-out pins. Repair if necessary. If no problems are found, replace neutral position switch.
Fig 5: Locating Neutral Position Switch Harness Connector (I30)
G96F10616Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 6: DTC 705, Checking Ground Circuit (I30)
G96G10617Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 7: DTC 705, Checking Input Signal Circuit (I30)
G96H10618Courtesy of NISSAN MOTOR CO., U.S.A.