LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1996 >> I30 Base, Automatic, RE4F04A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes 3.0L >> Circuit Tests >> DTC P0500 - Vehicle Speed Sensor (VSS)

DTC P0500 - Vehicle Speed Sensor (VSS)

  1. Check Speedometer Operation Raise and support drive wheels. Start engine. With transaxle in gear, check speedometer operation. If speedometer exceeds 6 MPH, go to next step. If speedometer exceeds 6 MPH, repair speedometer as necessary.
  2. Check Component Disconnect vehicle speed sensor connector at wheel. Using an ohmmeter, check continuity across speed sensor harness connectors while rotating one driving wheel. Resistance should fluctuate between zero and infinite ohms. If resistance is as specified, go to next step. If resistance is not as specified, replace VSS.
  3. Check Input Signal Circuit Turn ignition off. Disconnect ECM harness connector and combination meter harness connector. Check harness continuity between ECM terminal No. 29 and combination meter terminal 14 (Pink/Blue wire). See Fig 1. If continuity is present, testing is complete. If continuity is not present, repair harness or connectors as necessary and perform FINAL CHECK .
Fig 1: DTC P0500, Checking Input Signal Circuit (I30)
G96B10604Courtesy of NISSAN MOTOR CO., U.S.A.