DTC P0110 - Intake Air Temperature (IAT) Sensor
- Check Power Supply Turn ignition off. Disconnect IAT sensor harness connector. See Fig 1. Turn ignition on. Measure voltage between IAT sensor harness connector terminal "2" (Light Blue wire) and ground. See Fig 2. If voltage is approximately 5 volts, go to next step. If voltage is not 5 volts, verify harness continuity of Light Blue wire between IAT sensor and ECM. Repair harness or connectors as necessary.
- Check Ground Circuit Turn ignition off. Check IAT sensor harness continuity between terminal "1" (Black wire) and engine ground. See Fig 3. If continuity is present, go to next step. If continuity is not present, verify harness continuity between IAT sensor and ECM. Repair harness or connectors as necessary.
- Check Component Ensure IAT sensor is not damaged or contaminated. Check ECM and IAT sensor harness connectors for damage, corrosion or pushed-out pins. Repair if necessary. If no problems are found, ensure ignition is off.
- Measure resistance between IAT sensor harness connector terminals as follows:
- With intake air temperature at 68°F (20°C), resistance should be 2100-2900 ohms.
- With intake air temperature at 122°F (50°C), resistance should be 680-1000 ohms.
If resistance is not as specified, replace IAT sensor. If resistance is as specified, inspect ECM connector and terminals for damage or corrosion. Repair or replace as necessary.