LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1995 >> G20 Automatic, RE4F03A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes 2.0L >> Diagnostic Trouble Code (DTC) Testing >> DTC 98: Engine Coolant Temperature (ECT) Sensor

DTC 98: Engine Coolant Temperature (ECT) Sensor

  1. Check Power Supply

    Turn ignition off and disconnect ECT sensor harness connector. See Figure . Turn ignition on. Measure voltage between ECT sensor harness connector terminal "A" (Blue/Orange wire) and ground. See Figure . If voltage is approximately 5 volts, go to next step. If voltage is not 5 volts, verify harness continuity of Blue/Orange wire between ECT sensor and ECM. Repair harness or connectors as necessary.
  2. Check Ground Circuit

    Turn ignition off. Check ECT sensor harness continuity between terminal "B" (Black wire) and engine ground. See Figure . If continuity is present, go to next step. If continuity is not present, verify harness continuity between ECT sensor and ECM. Repair harness or connectors as necessary.
  3. Check Component

    Ensure thermostat functions correctly. Ensure ECT sensor is not damaged or contaminated. Check ECM and ECT sensor harness connectors for damage, corrosion or pushed-out pins. Repair if necessary. If no problems are found, ensure ignition is off.
  4. Measure resistance between ECT sensor harness connector terminals. Ensure resistance is as follows:
    • Coolant temperature 68°F (20°C); 2100-2900 ohms.
    • Coolant temperature 122°F (50°C); 680-1000 ohms.
    • Coolant temperature 194°F (90°C); 236-260 ohms.

If resistance is not as specified, replace ECT sensor.