LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1995 >> G20 Automatic, RE4F03A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes 2.0L >> Diagnostic Trouble Code (DTC) Testing >> DTC 34: Knock Sensor (KS)

DTC 34: Knock Sensor (KS)

  1. Check Input Signal Circuit

    Turn ignition off. Disconnect ECM harness connector and knock sensor harness connector. See Figure and Fig 1 . Verify harness continuity between knock sensor connector terminal "b" (White wire) and ECM terminal No. 54. See Fig 2 . If continuity is present, go to n ext step. If continuity is not present, repair harness or connectors as necessary.
  2. Check Component

    Disconnect knock sensor wiring harness connector. Check for continuity between sensor terminal "A" and ground. See Fig 3 . If continuity is not present, replace knock sensor. If continuity is present, disconnect ECM and KS wiring harness connector. Check terminals for damage or corrosion. Repair if necessary and perform FINAL CHECK.
Fig 1: Locating Knock Sensor Harness Connector (G20)
G95C31882Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 2: DTC 34, Checking Input Signal Circuit (G20)
G95D31883Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 3: DTC 34, Knock Sensor (G20)
G95E31884Courtesy of NISSAN MOTOR CO., U.S.A.