LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1995 >> G20 Automatic, RE4F03A >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes 2.0L >> Diagnostic Trouble Code (DTC) Testing >> DTC 12: Mass Airflow (MAF) Sensor

DTC 12: Mass Airflow (MAF) Sensor

  1. Check Power Supply

    Turn ignition off and disconnect MAF sensor harness connector. Turn ignition on. Measure voltage between MAF sensor harness connector terminal "B" (Orange wire) and ground. See Fig 1 and Fig 2 . If battery voltage is present, go to next step. If battery voltage is not present, verify harness continuity between MAF sensor and ECM, and MAF sensor and ECCS relay. Repair harness or connectors as necessary.
  2. Check Ground Circuit

    Turn ignition off and disconnect ECM harness connector. Check continuity between MAF sensor connector terminal "C" (White wire) and ECM terminal No. 48. See Figure , Figure and Fig 3 . If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
  3. Check Input Signal Circuit

    Check continuity between MAF sensor connector terminal "D" (Orange wire) and ECM harness connector terminal No. 47. See Fig 4 . I f continuity is not present, repair harness or connectors as necessary.
  4. Check Component

    Ensure MAF sensor hot wire is not damaged or contaminated. Check ECM and MAF sensor harness connectors for damage, corrosion or pushed-out pins. Repair if necessary. If no problems are found, turn ignition on.
  5. Measure voltage between ground and MAF sensor harness connector terminals "A". See Fig 5 .. Voltage should be as follows:
    • Key on, engine off; less than one volt.
    • Key on, engine running; 1.3-1.7 volts.
    • Engine running at about 4000 RPM; approximately 4.0 volts.

If voltage is not as specified, and hot wire is not damaged or contaminated, replace MAF sensor.

Fig 1: Locating MAF Sensor Harness Connector (G20)
G95C31858Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 2: DTC 12, Checking Power Supply (G20)
G95D31859Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 3: DTC 12, Checking Ground Circuit (G20)
G95G31860Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 4: DTC 12, Checking Input Signal Circuit (G20)
G95H31861Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 5: DTC 12, Checking MAF Sensor (G20)
G95I31862Courtesy of NISSAN MOTOR CO., U.S.A.