LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1994 >> G20 Automatic, RE4F03V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Trouble Code (DTC) Testing (G20) >> DTC 35: EGR Temperature Sensor (CALIF.)

DTC 35: EGR Temperature Sensor (CALIF.)

  1. Check Power Supply

    Turn ignition off and disconnect EGR temperature sensor harness connector. Turn ignition on. Measure voltage between EGR temperature sensor connector terminal "a" (Blue wire) and ground. See Fig 1 and Fig 2 . If voltage is approximately 5 volts, go to next step. If voltage is not as specified, repair harness or connectors as necessary.
    Fig 1: Locating EGR Temperature Sensor Connector
    G93A78634Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: DTC 35, Checking Power Supply
    G93B78635Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Check Ground Circuit

    Turn ignition off. Verify harness continuity between EGR temperature sensor connector terminal "b" (Black wire) and engine ground. See Fig 3 . If continuity is present, go to next step. If continuity is not present, repair harness or connectors as necessary.
  3. Check Component

    Inspect EGR temperature sensor. See SYSTEM & COMPONENT TESTING article. Replace EGR temperature sensor if necessary and perform FINAL CHECK.
    Fig 3: DTC 35, Checking Ground Circuit
    G93C78636Courtesy of NISSAN MOTOR CO., U.S.A.