Retrieving Codes
For DTC retrieval procedures, see Fig 1 . For description of DTC's, see DIAGNOSTIC TROUBLE CODES table.
Determine the DTC No. by counting the number of times the warning lamp flashes on and off. When several malfunctions occur at one time, up to 3 code numbers can be stored; the latest malfunction will be indicated first. The indication begins with the start code 12. See Fig 2 . After that a maximum of 3 code numbers appear in the order of the latest one first. The indication then returns to the start code 12 to repeat (the indication will stay on for 5 minutes at the most).
DIAGNOSTIC TROUBLE CODES
| DTC | Malfunctioning Part Or Unit | Diagnostic Procedure No. |
|---|---|---|
| 16 | Stop Lamp Switch Circuit | 8 |
| 18 | Sensor Rotor | 4 |
| 21 | Right Front Sensor (Open Circuit) | 4 |
| 22 | Right Front Sensor (Short Circuit) | 4 |
| 25 | Left Front Sensor (Open Circuit) | 4 |
| 26 | Left Front Sensor (Short Circuit) | 4 |
| 31 | Right Rear (Open Circuit) | 4 |
| 32 | Right Rear (Short Circuit) | 4 |
| 35 | Left Rear Wheel Sensor Circuit | 4 |
| 36 | Motor & Motor Relay | 4 |
| 41 | Solenoid Valve Relay | 3 |
| 45 | Control Unit | 3 |
| 55 | Control Unit Power Supply Or Ground Circuit | 3 |
| 57 | Power Supply (Low Voltage) | 7 |
| 61 | Actuator Motor Or Motor Relay | 5 |
| 63 | Solenoid Valve Relay Circuit (Except Power Supply For Relay Coil) | 6 |
| 71 | Control Unit | 9 |
| Warning Lamp Stays ON When Ignition Switch Is Turned On | Control Unit Power Supply, Warning Lamp Bulb Circuit, Control Unit Or Control Unit Connector, Solenoid Valve Relay Stuck, Power Supply For Solenoid Valve Relay Coil | 2 |
| Warning Lamp Stays On During Self-Diagnosis | Control Unit | N/A |
| Warning Lamp Does Not Come On When Ignition Switch Is Turned On | Fuse, Warning Lamp Bulb, Warning Lamp Circuit Or Control Unit | 1 |
| Warning Lamp Does Not Come On During Self-Diagnosis | Control Unit | N/A |