LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2025 >> Elantra Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.0L (Except HEV) >> Oil Pressure & Oil Temperature Sensor (OPTS) >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Lift the vehicle.
  3. Remove the engine room under cover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  4. Disconnect the connector (A), and then remove the sensor (B).

    Tightening Torque: 

    14.7 - 21.6 N.m (1.5 - 2.2 kgf.m, 10.8 - 15.9 lb-ft)

    G16698752Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
  • Install the component to the specified torques.
  • Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
  • Apply the sealant to the sensor.
  • Insert the sensor in the installation hole and be careful not to damage it during installation.