LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Kona SEL Plus, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L (3 Of 3) >> DTC P0620-00: Alternator Control Circuit >> Component Inspection >> PCM Check

PCM Check

  1. Turn the ignition switch "OFF".
  2. Select "vehicle Scope-Meter" in the menu, and connect channel A of GDS with FR terminal of Generator harness connector.
  3. Connect Channel B of GDS with C terminal of Generator harness connector.
  4. Engine start. And check the signal waveforms. (Compare the signal waveform of electrical loads ON with OFF)

    Specification:  Refer to Signal Waveform & Data below

    G12592592Courtesy of HYUNDAI MOTOR AMERICA
    G12592593Courtesy of HYUNDAI MOTOR AMERICA
  5. Is the measured signal waveforms of Generator normal?

    YES 

    NO 

    • Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.