| Case 1 |
Main Action |
|
- Contact resistance in connectors
- Faulty PCM
|
| Prerequisite Condition |
- Ignition key is turned "ON" or
- Engine is running
|
| Threshold Value |
- Actual value is higher or lower than allowable range
- Engine speed with ETC limp home activated is higher than 1760 RPM
- Torque monitoring error occurred
- Difference between actual and set point is bigger than 22~400Nm.
|
| Diagnosis Time |
|
| Case 2 |
Main Action |
- Check RAM and communication connections
|
| Prerequisite Condition |
- Ignition key is turned "ON"
|
| Threshold value |
- Failure in RAM test, checksum and/or SPI communication
|
| Diagnosis Time |
|
| Case 3 |
Main Action |
|
| Prerequisite Condition |
- Ignition key is turned "ON"
|
| Threshold Value |
- RAM/ROM error on μ-controller, checksum check
- Communication failure between main controller and monitoring unit
- Process monitoring test calculation failed
|
| Diagnosis Time |
|
| MIL-On Condition |
|