LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2020 >> Elantra Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (IVT Control System - 2.0L) >> Driven Pulley Speed Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  2. Remove the battery and battery tray.

    (Refer to Body Electrical System - "BATTERY , and BATTERY TRAY ")

  3. Disconnect the driven pulley speed sensor connector (A).
    G14084619Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the driven pulley speed sensor (A) after loosening the bolt.

    Tightening torque:  9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)

    G14084620Courtesy of HYUNDAI MOTOR AMERICA