LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2020 >> Elantra Eco >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Brake System) >> Brake Line >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2019 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery cable.
  2. Disconnect the brake fluid level switch connector.
    G12973284Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the brake fluid from the master cylinder reservoir with a syringe.
    NOTE:
    • Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
  4. Remove the wheel & tire.
  5. Remove the brake hose clip (A).
  6. Disconnect the brake tube by loosening the tube flare nut (B).

    Tightening Torque: 

    12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb-ft)

    [Front] 

    G12973285Courtesy of HYUNDAI MOTOR AMERICA

    [Rear] 

    G12973286Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the brake hose by loosening the bolt (A) & (B).

    Tightening Torque: 

    24.5 - 29.4 N.m (2.5 - 3.0 kgf.m, 18.1 - 21.7 lb-ft)

    [Front] 

    G12973287Courtesy of HYUNDAI MOTOR AMERICA

    [Rear disc] 

    G12973288Courtesy of HYUNDAI MOTOR AMERICA

    [Rear Drum] 

    G12973289Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the brake hose bracket by loosening the bolt (A). [Drum brake only]

    Tightening Torque: 

    18.6 - 25.5 N.m (1.9 - 2.6 kgf.m, 13.7 - 18.8 lb-ft)

    G12973290Courtesy of HYUNDAI MOTOR AMERICA