LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2019 >> Elantra SEL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Fuel Delivery System - 1.6L) >> Fuel Line >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF, and then remove battery (-) terminal.
  3. Disconnect the fuel feed tube quick-connector (A).
    G12971956Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Open the clamp cover (B) before disconnect the quick connector. (If the clip is applied)
      G12971957Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • When removing the quick-connnector with the clip removing tool (A), be careful not to damage the plastic clip (B).
    • If the clip is damaged, fuel line leak can be occurred due to a bad connection.
      G12971958Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the vapor hose (A) which is connected from the PCSV.
    G12971959Courtesy of HYUNDAI MOTOR AMERICA
  5. Lift the vehicle.
  6. Remove the fuel tank.

    (Refer to Fuel Delivery System - "Fuel Tank ")

  7. Remove the vapor tube and low fuel line fixing clip (A) by using a common driver.
    G12971960Courtesy of HYUNDAI MOTOR AMERICA
    G12971961Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the fuel line (A) after loosening the mounting bolts and brackets.
    G12971962Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the fuel line (A).
    G12971963Courtesy of HYUNDAI MOTOR AMERICA