LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2019 >> Elantra SEL >> Repair and Diagnosis >> Body & Frame >> Seats >> Front Seat Assembly >> Front Seat Back Cover >> Repair Procedures >> Replacement

Repair Procedures: Replacement

CAUTION:
  • Put on gloves to prevent hand injuries.

Information 

  1. Remove the front seat assembly.

    (Refer to Front Seat - "FRONT SEAT ASSEMBLY ")

  2. Remove the front seat shield outer cover.

    (Refer to Front Seat - "FRONT SEAT SHIELD OUTER COVER ")

  3. Remove the front seat shield inner cover.

    (Refer to Front Seat - "FRONT SEAT SHIELD INNER COVER ")

  4. Remove the front seat lower protector (A).
    G12974811Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the mounting screws and remove the airbag wiring (A).
    G12974812Courtesy of HYUNDAI MOTOR AMERICA
  6. Push the lock pin, remove the front seat headrest (A).
    G12974813Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the front seat back board (A).
    1. Separate the upper back cover by pushing the lock pin in the direction of the arrow.
    2. Remove the front seat back cover by lifting in the direction.
    G12974814Courtesy of HYUNDAI MOTOR AMERICA
    G12974815Courtesy of HYUNDAI MOTOR AMERICA
  8. Turn the front seat back cover inside out. Then pull out the headrest guides (A) while pinching both side of the lower part of the guides, and remove them.
    G12974816Courtesy of HYUNDAI MOTOR AMERICA
    G12974817Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the front air ventilation duct (A).

    [Upper] 

    G12974818Courtesy of HYUNDAI MOTOR AMERICA

    [Lower] 

    G12974819Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the protector (A) from the front seat back frame.
    G12974820Courtesy of HYUNDAI MOTOR AMERICA
  11. After removing the Velcro tape (A) and hog-ring clips (B) inside the front seat back cover, remove the seat back cover (C).
    CAUTION:
    • Be careful not to allow the sponge insert wire to separated in its place.
    G12974821Courtesy of HYUNDAI MOTOR AMERICA
  12. To install, reverse the removal procedure.

    Information 

    • Make sure that the connectors are connected completely
    • Replace any damaged clips (or pin-type retainers).
    • To prevent wrinkles, make sure that the cover (B) is stretched evenly before connecting the hog-ring clips (A).
    • Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
G12974822Courtesy of HYUNDAI MOTOR AMERICA