LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2019 >> Elantra Eco >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Idle Stop & Go (ISG) System >> Starter >> Repair Procedures >> Inspection >> Starter Solenoid Inspection

Starter Solenoid Inspection

  1. Disconnect the lead wire from the M-terminal of solenoid switch.
  2. Connect the battery as shown. If the starter pinion pops out, it is working properly.
    NOTE:
    • To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
    G12977248Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the battery from the M terminal.

    If the pinion does not retract, the hold-in coil is working properly.

    NOTE:
    • To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
    G12977249Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the battery also from the body. If the pinion retracts immediately, it is working properly.
NOTE:
  • To avoid damaging the starter, do not leave the battery connected for more than 10 seconds.
G12977250Courtesy of HYUNDAI MOTOR AMERICA