LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson SEL Plus, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L (3 Of 3) >> DTC P2195: O2 Sensor Signal Stuck Lean (Bank 1 Sensor 1) >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

Linear 

Item Detecting Condition Possible Cause
DTC Strategy
  • Monitor HO2S's signal
  1. Poor connection or damaged harness
  2. Front HO2S
Enable Conditions
  • Downstream O2 sensor operative readiness
  • Engine speed is higher than 600 rpm
  • Mass air flow is less than 83g/sec (300 kg/h)
  • Exhaust gas temp. is between 300°C (572°F) and 800°C (1472°F)
  • After fuel-cut, catalyst purge is not working
  • Stabilization Conditions
    • Absolute value (engine rpm-filtered engine rpm) is lower than 500 rpm
    • Absolute value (Air mass-filtered air mass) is lower than 0.4 g/rev (200 mg/stk)
    • Absolute value (Lambda value-filtered lambda value) is less than 15%
Threshold value
  • Plausibility between upstream and downstream
  • Upstream lean & downstream rich & lambda controller limit or upstream rich & downstrean lean & lambda controller limit
Diagnosis Time
  • 5~ 100 sec. (depends on intake air mass)
MIL On Condition
  • 2 Driving Cycles