LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson SEL Plus, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L (2 Of 3) >> DTC P0564: Cruise Control Multi-Function Input A Circuit >> Component Inspection >> Check auto cruise switch

Check auto cruise switch

  1. IG key OFF.
  2. Disconnect 'CRUISE REMOCON SWITCH' connector.
  3. Measure resistance between 'Signal (Cruise sw)' terminal and 'Ground (Cruise sw)' terminals of 'CRUISE REMOCON SWITCH' harness connector (Component side)

    Specification: 

    Item Resistance (Ω) Item Resistance (Ω)
    CRUISE MAIN switch 3.9 kΩ ± 5% COAST SET switch 220 Ω ± 5%
    CANCEL switch 0 Ω ± 5% RESUME/ACCEL switch 910 Ω ± 5%
    G12603566Courtesy of HYUNDAI MOTOR AMERICA
  4. Is the measured value within specification?

    YES 

    NO 

    • Replace 'CRUISE REMOCON SWITCH' and go to "Verification of Vehicle Repair " procedure.
      NOTE: There is a memory reset function on GDS that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others.