LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson SEL Plus, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L (1 Of 3) >> DTC P0113: Intake Air Temperature Sensor 1 Circuit High Input >> DTC Inspection >> GDS Data Analysis

GDS Data Analysis

  1. Connect GDS and select "DTC Analysis" mode
  2. Warm up the engine.
  3. Monitor the parameters related to DTC on the "Current Data" menu of the GDS as below while press and depress gas pedal.
    G12603308Courtesy of HYUNDAI MOTOR AMERICA

    Fig.1) Engine warmed up state (water temperature is 99.8°C (211.64°F)

  4. Is parameter displayed within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.

    NO 

    • Go to next step.