Component Inspection
- IG "OFF".
- IG "ON".
- Connect GDS and select "Diagnostic Trouble Codes (DTC) " mode.
- Using a GDS, Clear DTC.
- Check if the pressure sensor's service data shows '0 bar' on the GDS while not pressing the brake pedal.
- Use the GDS and check that the pressure sensor value rises while pressing the brake pedal.
- Is the pressure sensor's data unusually shown?
YES
- Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.NOTE: * In a case of replacing HECU, operate following functions
1) "Steering Angle Sensor Calibration" for steering angle sensor offset correction (refer to C1261 ) -ESP(ESC) only
2) "Longitudinal Sensor Calibration" for Longitudinal sensor offset correction (refer to C1285 ) - ESP(ESC) only
3) "Variant Coding" for option coding (refer to C1702 )
NO
- This fault is intermittently caused by pressure sensor. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good HECU and check for proper operation. If problem is corrected, replace HECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.