LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Turbo R-Spec, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 1.6L GDI) >> Knock Sensor (KS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Remove the Intake Manifold (Refer to: "Intake And Exhaust System" in EM procedure).
  3. Disconnect the Injector Connector (A).
  4. Remove the Installation Bolt (B) and then remove the Sensor from the Cylinder Block.
    Fig 1: Injector Connector And Sensor Installation Bolt
    G10607942Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals