LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Tucson SE, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Automatic Transaxle Control System - 2.0L) >> Inhibitor Switch >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set shift lever to "N" position.
  2. Remove the air duct.

    (Refer to INTAKE MANIFOLD ")

  3. Remove the battery and the battery tray.

    (Refer to BATTERY )

  4. Disconnect the inhibitor switch connector (A).
  5. Remove the shift cable mounting nut (B).

    Tightening torque: 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

    Fig 1: Identifying Inhibitor Switch Connector And Shift Cable Mounting Nut
    G09815407Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the manual control lever (B) and the washer after removing a nut (A).

    Tightening torque: 

    17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

    Fig 2: Identifying Manual Control Lever And Nut
    G09815408Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: Use a SST (09480-A3800) or 0.19609 in. (5 mm) bolt, fix the inhibitor manual control lever in the "N" jig hole (A) when you assemble the inhibitor (B).
    Fig 3: Fixing Inhibitor Manual Control Lever In "N" Jig Hole
    G09815409Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the inhibitor assembly (A) after removing the bolts (2 ea).

    Tightening torque: 

    9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Fig 4: Identifying Inhibitor Assembly
    G09815410Courtesy of HYUNDAI MOTOR AMERICA