LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Elantra Coupe Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System - 2.0L >> Fuel Line >> Repair procedures >> Removal

Repair procedures: Removal

  1. Turn the ignition switch OFF, and then remove battery (-) cable.
  2. Release the residual pressure in fuel line.

    (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  3. Disconnect the low pressure fuel quick-connector (A).
    Fig 1: Low Pressure Fuel Quick-Connector
    G10255847Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the vapor hose (A) which is connected from the PCSV.
    Fig 2: Vapor Hose
    G10255848Courtesy of HYUNDAI MOTOR AMERICA
  5. Lift the vehicle.
  6. Remove the fuel tank.

    (Refer to "FUEL TANK ")

  7. Remove the vapor tube and low fuel line fixing clip (A) by using a common driver.
    Fig 3: Removing Vapor Tube And Low Fuel Line Fixing Clips
    G10255849Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the installation nuts, and then push the heat protector in the direction of an arrow.
    Fig 4: Removing Heat Protector
    G10255850Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the installation bolts (A), and then remove the fuel line fixing clip (B).
    Fig 5: Removing Fuel Line Fixing Clip
    G10255851Courtesy of HYUNDAI MOTOR AMERICA
  10. Release the fuel & brake line protector (A) by disconnecting the fixing clip.
    Fig 6: Removing Fuel & Brake Line Protector
    G10255852Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the fuel line.
    Fig 7: Removing Fuel Line
    G10255853Courtesy of HYUNDAI MOTOR AMERICA