LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Elantra Coupe Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Windows >> Interior >> Interior Trim >> Repair procedures >> Replacement >> Package Tray Trim Replacement

Package Tray Trim Replacement

CAUTION:
  • Put on gloves to protect your hands.
  • Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
  • Take care not to bend or scratch the trim and panels.
  1. Remove the rear seat assembly.

    (Refer to "REAR SEAT ")

  2. Remove the front door scuff trim.
  3. Using a screwdriver or remover, remove the rear pillar trim (A).
    Fig 1: Rear Pillar Trim
    G10254324Courtesy of HYUNDAI MOTOR AMERICA
  4. After loosening the mounting screws and clips, then remove the partition side trim (A).
    Fig 2: Loosening Partition Side Trim Mounting Screws And Clips
    G10254325Courtesy of HYUNDAI MOTOR AMERICA
  5. After loosening the mounting screws, then remove the center pillar lower trim (A).
    Fig 3: Loosening Center Pillar Lower Trim Mounting Screws
    G10254326Courtesy of HYUNDAI MOTOR AMERICA
  6. After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

    Tightening torque: 

    39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

    Fig 4: Loosening Rear Seat Belt Lower Anchor Mounting Bolt
    G10254327Courtesy of HYUNDAI MOTOR AMERICA
  7. Using a screwdriver or remover, remove the package tray trim (A).
    Fig 5: Package Tray Trim
    G10254328Courtesy of HYUNDAI MOTOR AMERICA
  8. Installation is the reverse of removal.
    NOTE:
    • Make sure the connector is connected properly.
    • Replace any damaged clips.