LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Veloster Standard Trans >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel Module Diagnosis >> DTC B1699: CAN timeout between IPM and AVAVN >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC, keep the vehicle condition within "the enable conditions" (Refer to "DTC DETECTING CONDITION " table).
    Fig 1: Display - DTC Screen
    G08812877Courtesy of HYUNDAI MOTOR AMERICA
  5. Is the same DTC occurred again?

    YES 

    Go to next procedure.

    NO 

    Fault is intermittent caused by poor contact in IPM's and/or AV/AVN's connector or was repaired and IPM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.