LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Veloster Standard Trans >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel Module Diagnosis >> DTC B1215: Rear Center Left Sensor Fault >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "DTC Analysis" mode.
  4. After erase DTC.
    Fig 1: Display - DTC Screen
    G08812901Courtesy of HYUNDAI MOTOR AMERICA
  5. Is the same DTC occurred again?

    YES 

    Go to next procedure.

    NO 

    Fault is intermittent caused by poor contact in the sensor's and/or IPM[RPAS (Rear Parking Assist Module)]'s connector. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.