LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Elantra Touring GLS, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Inspection Chart For Diagnostic Trouble Codes (DTC) >> P0880: TCM Power Signal Error Open/Short (GND) >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to data link connector (DLC)
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "BATTERY VOLTAGE" parameter on the GDS
    Fig 1: Scantool Display - Battery Voltage Parameter Ignition ON A/T RELAY
    G06136483Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Scantool Display - Battery Voltage Parameter Idle A/T Relay
    G06136484Courtesy of HYUNDAI MOTOR CO.
  4. Does "BATTERY VOLTAGE" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM/TCM's connector or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO