LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Elantra Touring GLS, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Inspection Chart For Diagnostic Trouble Codes (DTC) >> P0721: Output Speed Sensor Circuit Range/Performance >> Monitor GDS Data

Monitor GDS Data

  1. Connect scantool to data link connector (DLC)
  2. Engine "ON".
  3. Monitor the "INPUT SPEED SENSOR" parameter on the scantool.
  4. Drive the vehicle

    Specification  : Increasing Gradually

    Fig 1: Scantool Display - Selector Lever P, N Range
    G06136380Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Scantool Display - Selector Lever R Range
    G06136381Courtesy of HYUNDAI MOTOR CO.
    Fig 3: Scantool Display - Selector Lever D Range
    G06136382Courtesy of HYUNDAI MOTOR CO.
    Fig 4: Scantool Display - Selector Lever 3 Range
    G06136383Courtesy of HYUNDAI MOTOR CO.
    Fig 5: Scantool Display - Selector Lever 2 Range
    G06136384Courtesy of HYUNDAI MOTOR CO.
    Fig 6: Scantool Display - Selector Lever L Range
    G06136385Courtesy of HYUNDAI MOTOR CO.
  5. Does "input speed sensor" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO