LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2012 >> Elantra Touring GLS, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System >> Inspection Chart For Diagnostic Trouble Codes (DTC) >> P0721: Output Speed Sensor Circuit Range/Performance >> Component Inspection >> Check PCM/TCM

Check PCM/TCM

  1. Ignition "ON" & Engine "OFF".
  2. Connect "OUTPUT SPEED SENSOR" connector.
  3. Install scantool and sleet a SIMU-SCAN,
  4. Simulate frequency to OUTPUT SPEED SENSOR signal circuit.
    Fig 1: Scantool Display - Output Speed Sensor Output 150 Hz → 133 RPM
    G06136398Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Scantool Display - Output Speed Sensor Output 250 Hz → 222 RPM
    G06136399Courtesy of HYUNDAI MOTOR CO.

    The values are subject to change according to vehicle model or conditions

  5. Is "OUTPUT SPEED SENSOR" signal value changed according to simulation frequency?

    YES 

    • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.