Component Inspection
- Check injector
- IG "OFF" and disconnect injector connector.
- Measure resistance between power and control terminals of injector connector. (Component side)
Specification: 14.5 ±~ 0.7Ω (at 20°C/68°F)
- Is the measured resistance within specification?
YES
- Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good injector and check for proper operation. If the problem is corrected, replace injector and go to "VERIFICATION OF VEHICLE REPAIR " procedure.