LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Elantra SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC P0300: Random Multiple Cylinder Misfire Detected >> Inspection/Repair >> System Inspection >> Timing Inspection

Timing Inspection

  1. With ignition "OFF", set up an oscilloscope as follows:

    Channel A (+): terminal 3 of the Crankshaft Position Sensor(CKPS), (-): ground

    Channel B (+): terminal 3 of the Camshaft Position Sensor(CMPS), (-): ground

  2. Start the engine and check for signal waveform whether synchronize with camshaft sensor or not.
    Fig 1: Signal Waveform - Falling Edge
    G06856297Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Signal Waveform - Rising Edge
    G06856298Courtesy of HYUNDAI MOTOR CO.
  3. Is the signal waveform normal?

    YES 

    • Go to next step as below

    NO 

    • Repair or readjust as necessary, if air gap of the CKPS is exceeds specification[0.3~1.7 mm (0.012~0.067 in)]. If OK, check that the crankshaft and camshaft are correctly aligned the matching marks of the pulleys. Repair or readjust as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure