LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Elantra SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC P0198: Engine Oil Temperature Sensor High Input >> Inspection Repair >> W/Harness Inspection >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check the signal circuit for short to battery
    1. Disconnect ECM harness connector
    2. Ignition "ON" & Engine "OFF"
    3. Measure voltage between terminal 2 of the OTS harness connector and chassis ground.

      Specification  : Approx. 0V

      Fig 1: Measuring Voltage Between OTS Connector Terminal 2 And Chassis Ground
      G06856238Courtesy of HYUNDAI MOTOR CO.
    4. Is voltage within specification?

      YES 

      • Go to next step as below

      NO 

  2. Check the signal circuit for open
    1. Ignition "OFF"
    2. Measure resistance between terminals 2 of the OTS harness connector and 40 of the ECM harness connector.

      Specification  : Approx. 0Ω

      Fig 2: Measuring Resistance Between OTS Harness Connector Terminals 2 And ECM Harness Connector Terminal 40
      G06856239Courtesy of HYUNDAI MOTOR CO.
    3. Is resistance within the specification?

    YES 

    • Go to next step as below

    NO