LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Elantra SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC P0117: Engine Coolant Temperature Circuit Low Input >> Inspection Repair >> Component Inspection

Component Inspection

  1. Measure resistance between terminals 1 and 3 of the sensor connector (Component side)

    Specification  :

    TEMPERATURE AND RESISTANCE SPECIFICATION

    Temp. (°C) Temp. (°F) Resistance (kΩ) Temp. (°C) Temp. (°F) Resistance (kΩ)
    -20 -4 14.1 ~ 16.8 40 104 Approx. 1.2
    0 32 Approx. 5.8 60 140 Approx. 0.6
    20 68 2.3 ~ 2.6 80 176 Approx. 0.3
    Fig 1: Measuring Resistance Between Terminals 1 And 3 Of Sensor Connector
    G06856124Courtesy of HYUNDAI MOTOR CO.
  2. Is resistance within the specification?

    YES 

    • Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    • Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure