LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Elantra SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC P0116: Engine Coolant Temperature Circuit Range Performance >> Scantool Diagnostics >> Monitor Scantool Data

Monitor Scantool Data

  1. Allow the engine to cool completely
  2. Run the cold engine at idle for 5 minutes and observe cooling fan status.
    NOTE: Ensure that the A/C is OFF
  3. Check the engine coolant temperature parameter at idle with the scantool.
  4. Is the engine coolant temperature increase to above 50°C(122°F)

    YES 

    NO 

    • Go to next step as below
  5. Are the cooling fans running when engine coolant temperature is low(less than approximately 98°C(208°F)) with A/C OFF?

    YES 

    NO 

    1. With ignition "ON", Install scantool and select "COOLING FAN RELAY" on the Actuation Test mode.
    2. Activates "COOLING FAN RELAY" by pressing "STRT(F1)" key
    3. Repeat this procedure 4 or 5 times to ensure cooling fan reliability.
    4. If cooling fan works properly, go to next step as below
    5. If NG, check for intermittent fault caused by poor contact in the sensor's and/or ECM's connector.