LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Elantra SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 2) >> DTC P0103: Massor Volume Air Flow Circuit high Input >> Inspection Repair >> Component Inspection

Component Inspection

  1. Engine "ON"
  2. Install Scantool and monitor the "MASS AIR FLOW(V)" parameter on the Scantool data list.
  3. Monitor the "MASS AIR FLOW" parameter on the Scantool.

    Specification  :

    TEST CONDITION SPECIFICATION

    Test Condition MAFS(V)
    Normal value with ignition "ON" & Engine "OFF" Approx. 0.1
    Normal value with idle after warm up Approx. 0.9~1.3
    2000RPM without load Approx.1.6~2.0
    Normal value with accelerating and decelerating after starting The MAFS and TPS signals increase at the same time with accerlerating and decrease with releasing accelerator pedal
  4. Is MAF sensor voltage within the specification?

    YES 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    • Check MAF for contamination, deterioration, or damage. Substitute with a known-good MAF and check for proper operation. If the problem is corrected, replace MAF and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.