Component Inspection
- Check Tilt/Telescope module
- Connect scantool to Data Link Connector (DLC).
- Ignition "ON" & engine "OFF".
- Substitute with a known-good Tilt/Telescope module and Check if the DTC is erased
- Is the DTC erased?
YES
- Substitute with a known-good Tilt/Telescope module and check for proper operation. If the problem is corrected, replace Tilt/Telescope module and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to " 2 Check BCM" procedure.
- Check BCM
- Connect scantool to Data Link Connector (DLC).
- Ignition "ON" & engine "OFF".
- Substitute with a known-good BCM and Check if the DTC is erased
- Is the DTC erased?
YES
- Substitute with a known-good BCM and check for proper operation.
If the problem is corrected, replace BCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good BCM and check for proper operation.